If your remote has blue buttons and 4 separate mode buttons (SAT TV VCR AUX)

If you start this procedure and at any time do not press a button within 20 seconds, the remote will end the procedure automatically. Simply start over again.

Press and hold the correct Mode button (about three seconds) until all mode keys light up, then release.

Use the number pad buttons to enter the three digit number corresponding to the equipment. The light will blink off after each digit is entered and then return to a steady light.

Press the POUND (#) button. If the code entered is valid for the remote, the mode light flashes three times.

To verify the code works, press the mode button and then try several functions for that equipment.

If your remote has 1 mode button at the top

If you start this procedure and at any time do not press a button within 20 seconds, the remote will end the procedure automatically. Simply start over.

With the desired equipment on, press and release the Mode button until the light flashes behind the correct mode.

Using the tip of a pen or the eraser on a pencil, press the address button.

Enter the code on the remote's numbered keypad for the equipment.

Press the Address button. If the code entered is valid for the remote, the mode light flashes three times.

To verify the code works, try several functions for that equipment. Some codes may provide partial functions or respond differently than the button's titled function. Try the other codes listed for that device until you find one that offers more complete functionality.

If the codes listed to not work Click Here

©2005 G&S Electronics, All Rights Reserved