Not Operating TV, VCR, Stereo or Auxiliary Equipment.

1. Verify you are using your DISH Network remote.
2. Make sure you are in the correct mode, (TV, VCR, AUX).
    
3. Press the appropriate mode button on your remote or the separate Mode button until the remote lights under the desired device.
4. Properly install new batteries in the remote.
   *See battery reference.
5. If you have separate mode buttons at the top of your remote, follow these steps:
• With the desired equipment on, press and hold the correct mode button, (TV, VCR, AUX) until all the mode button lights come on, then release.
• Press and release the Power button.
• Press the Up arrow button once a second while pointing the remote at the desired piece of equipment.
• When the equipment turns off, press the pound (#) button.
6. If you have a single mode selection button at the top of your remote, follow these steps:
• With the desired equipment on, press and release the Mode button until the light under the desired mode lights up.
• Press the Address button on the remote.
• Press and release the Power button.
• Press the Up arrow button once a second while pointing the remote at the desired piece of equipment.
• When the equipment turns off, press the Address button.

©2005 G&S Electronics, All Rights Reserved