Not Operating Receiver

1. Verify you are using your DISH Network remote.
2. If you have more than one satellite receiver in your home, verify you are using the correct DISH Network remote for that box.
3. Make sure you are in SAT mode.
   Press either the SAT button on your remote or the Mode button until the remote lights under SAT.
4. Properly install new batteries in the remote.
   *See battery reference.
5. If you have a UHF receiver, make sure the UHF antenna on the back of the receiver is still connected.
6. If you do not have a UHF receiver, ensure that there is nothing blocking the view between your remote and the receiver's front panel.
7. Power the receiver off from the front panel.
8. Remove the Smart Card for 15 seconds then reinsert the card.
9. Power the receiver back on.

©2005 G&S Electronics, All Rights Reserved