Channels Not in Program Guide

1. Verify you are in the correct guide.
    
2. Receivers with favorite lists may be on a guide list that does not contain the channel you are looking for. Your receiver may be on ALL CHAN, ALL SUB or LIST 1. To change between the different guide lists, press the Guide button on your remote until you are on the one you want.
3. Power your receiver off and unplug it from the electrical outlet.
4. Wait 15 seconds, plug it back in and turn it on.
5. Press Menu on your remote.
6. Arrow to and select System Setup or Installation.
7. Arrow to and select Multi-DISH Install or Point Dish/Signal.
8. In this menu option you should have an option for Check Switch. If not, Cancel and select the other option in step 6.
9. Verify you have a green signal bar at the bottom of the screen.
10. Arrow to and select Check Switch.
11. Select Check.
12. Wait for summary and select OK.
13. On your remote, select Cancel, then View.

©2005 G&S Electronics, All Rights Reserved